A water well professional can help you schedule further inspection, maintenance and testing to keep your new well system operating at peak capacity. A properly constructed and maintained well can provide 20+ years of safe drinking water for you and your family.
Contents
Do wells run dry in Florida?
Since 1999, the Biscayne Aquifer has lost 580 square miles of its supply for 4 million residents, more than half the population in Southeast Florida. Water remains drinkable, but the water quality is concerning due to some contaminated coastal sites.
What is the average lifespan of a well?
Proper well design addressing current and future costs can save owners money. The design of a water well should reflect a consideration of its cost during the entire life of the well, typically from 25 to more than 100 years.
How deep are wells in Florida?
Wells in Leesburg, Florida can be extremely deep (up to 1000 feet or more). However, the most common depth is in the 100 to 400 foot depth range.
Do water wells go bad?
When water is drawn down below the pump level, the pump will bring air into the system instead of water. Calling in a professional to measure the water depth and lower the pump can quickly fix this problem. Another problem can be well age. A well’s lifespan is considered to be roughly 20 to 30 years.
Can I drill my own well in Florida?
All wells must be constructed by a licensed water well contractor. The only exception to this law is for a water well two (2) inches or less in diameter constructed by an individual for his/ her own private use on his/her owned or leased property as specified in Section 373.326(2), Florida Statutes.
How deep is the average well?
In general, private home wells tend to range from 100 to 500 feet in depth. However, they can be much deeper than this in some cases. There are even some wells that go past the 1,000 foot mark. The average well depth in your area will depend on several factors.
Do Wells last forever?
Most wells have a lifespan of 20-30 years. Since sediment and mineral scale build up overtime, water output may wane over the years.
When should I replace my well?
According to CroppMetCalf Services, your well pump system will typically last eight to 15 years. The more you use the pump, the more often it will need to be replaced. You can help extend the lifespan of your pump by getting regular maintenance checks.
How often do you replace a well?
Depending on the equipment type and model, well pumps typically last anywhere from 8 to 15 years.
How do well digger’s find water?
If there are no wells in the area, or not enough information is available on existing ones, the hydrologist may contract with a well driller to put down some test holes. At these holes a pumping or aquifer test will be conducted. These tests indicate the water-bearing properties of the aquifer tapped by the well.
How much does a well cost?
$3,750 – $15,300 (Average Cost) The average cost to put in a new water well is $3,750 to $15,300 while installing a well and septic system costs $6,000 to $20,000. Well drilling costs $25 to $65 per foot for a complete installation, or $15 to $25 per foot just to drill.
How long does it take to drill a well in Florida?
Depending on drilling conditions, well installation can take 1–2 days.
Can a well pump last 30 years?
The pressure tank on your well may be long-lived (up to 30 years) or may be a short-lived version (lasting around 5 years).If you’re unsure, ask your well pump contractor what type of tank you have and how old it is. Poor water quality with high amounts of rocks and other solids can also cause the tank to fail sooner.
Do house wells run out of water?
Can Your Well Run Out of Water? If your well has been correctly drilled, it can last your family a lifetime, but it is possible for a well to run dry. This often happens with wells that are too shallow. If a well is not drilled deep enough, it may only be a water table well.
Do well pumps need maintenance?
Always use licensed or certified water well drillers and pump installers when a well is constructed, a pump is installed, or the system is serviced. An annual well maintenance check, including a bacterial test, is recommended.
How far down is the water table in Florida?
The Floridan aquifer averages 1,000 feet thick, and freshwater can extend to a depth of 2,000 feet below land surface. Freshwater is thickest in the central portions of the state and rapidly thins toward the coast and the south.
How Far Should a well be from the house?
Any contamination in your neighbor’s well can travel into your well. Some activities legally require more than a 50-foot zone of protection. As a general guidance, personal drinking water wells should have a minimum horizontal distance of at least 10 feet and preferably 25 feet from such boundaries.
How do wells work in Florida?
They are created by digging a hole in the ground with a shovel or backhoe. Dug wells have usually been excavated below the groundwater table until incoming water exceeded the digger’s bailing rate. The well was then lined (cased) with stones, brick, tile, or other material to keep it from collapsing.
Can you drink well water?
Well water can be safe for drinking and all other household needs, as long as you make sure to test your water supply regularly and select treatment solutions in line with your results. Learn more about the well water treatment options that are available for your specific needs.
How do well drillers know where to drill?
If you want to find the the location to drill with the highest potential yield you need find the location to drill that the aquifer is the thickest and has the highest hydraulic conductivity. Using seismic technology and software customized for imaging aquifers we are able to find this for you before drilling.
